Publications | Max Planck Institute for Intelligent Systems

2018

am mg Ponton, B., Herzog, A., Del Prete, A., Schaal, S., Righetti, L. On Time Optimization of Centroidal Momentum Dynamics In 2018 IEEE International Conference on Robotics and Automation (ICRA), pages: 5776-5782, IEEE, Brisbane, Australia, 2018 (inproceedings)

Direct observations of sub-100 nm spin wave propagation in magnonic wave-guides

Träger, N., Gruszecki, P., Lisiecki, F., Förster, J., Weigand, M., Kuswik, P., Dubowik, J., Schütz, G., Krawczyk, M., Gräfe, J.

In 2018 IEEE International Magnetics Conference (INTERMAG 2018), IEEE, Singapore, 2018 (inproceedings)

mms

mms Träger, N., Gruszecki, P., Lisiecki, F., Förster, J., Weigand, M., Kuswik, P., Dubowik, J., Schütz, G., Krawczyk, M., Gräfe, J. Direct observations of sub-100 nm spin wave propagation in magnonic wave-guides In 2018 IEEE International Magnetics Conference (INTERMAG 2018), IEEE, Singapore, 2018 (inproceedings)

Unsupervised Contact Learning for Humanoid Estimation and Control

Rotella, N., Schaal, S., Righetti, L.

In 2018 IEEE International Conference on Robotics and Automation (ICRA), pages: 411-417, IEEE, Brisbane, Australia, 2018 (inproceedings)

Abstract

This work presents a method for contact state estimation using fuzzy clustering to learn contact probability for full, six-dimensional humanoid contacts. The data required for training is solely from proprioceptive sensors - endeffector contact wrench sensors and inertial measurement units (IMUs) - and the method is completely unsupervised. The resulting cluster means are used to efficiently compute the probability of contact in each of the six endeffector degrees of freedom (DoFs) independently. This clustering-based contact probability estimator is validated in a kinematics-based base state estimator in a simulation environment with realistic added sensor noise for locomotion over rough, low-friction terrain on which the robot is subject to foot slip and rotation. The proposed base state estimator which utilizes these six DoF contact probability estimates is shown to perform considerably better than that which determines kinematic contact constraints purely based on measured normal force.

am mg

am mg Rotella, N., Schaal, S., Righetti, L. Unsupervised Contact Learning for Humanoid Estimation and Control In 2018 IEEE International Conference on Robotics and Automation (ICRA), pages: 411-417, IEEE, Brisbane, Australia, 2018 (inproceedings)

Learning Task-Specific Dynamics to Improve Whole-Body Control

Gams, A., Mason, S., Ude, A., Schaal, S., Righetti, L.

In Hua, IEEE, Beijing, China, November 2018 (inproceedings)

Abstract

In task-based inverse dynamics control, reference accelerations used to follow a desired plan can be broken down into feedforward and feedback trajectories. The feedback term accounts for tracking errors that are caused from inaccurate dynamic models or external disturbances. On underactuated, free-floating robots, such as humanoids, high feedback terms can be used to improve tracking accuracy; however, this can lead to very stiff behavior or poor tracking accuracy due to limited control bandwidth. In this paper, we show how to reduce the required contribution of the feedback controller by incorporating learned task-space reference accelerations. Thus, we i) improve the execution of the given specific task, and ii) offer the means to reduce feedback gains, providing for greater compliance of the system. With a systematic approach we also reduce heuristic tuning of the model parameters and feedback gains, often present in real-world experiments. In contrast to learning task-specific joint-torques, which might produce a similar effect but can lead to poor generalization, our approach directly learns the task-space dynamics of the center of mass of a humanoid robot. Simulated and real-world results on the lower part of the Sarcos Hermes humanoid robot demonstrate the applicability of the approach.

am mg

link (url) [BibTex]

am mg Gams, A., Mason, S., Ude, A., Schaal, S., Righetti, L. Learning Task-Specific Dynamics to Improve Whole-Body Control In Hua, IEEE, Beijing, China, November 2018 (inproceedings)

link (url) [BibTex]

An MPC Walking Framework With External Contact Forces

Mason, S., Rotella, N., Schaal, S., Righetti, L.

In 2018 IEEE International Conference on Robotics and Automation (ICRA), pages: 1785-1790, IEEE, Brisbane, Australia, May 2018 (inproceedings)

Abstract

In this work, we present an extension to a linear Model Predictive Control (MPC) scheme that plans external contact forces for the robot when given multiple contact locations and their corresponding friction cone. To this end, we set up a two-step optimization problem. In the first optimization, we compute the Center of Mass (CoM) trajectory, foot step locations, and introduce slack variables to account for violating the imposed constraints on the Zero Moment Point (ZMP). We then use the slack variables to trigger the second optimization, in which we calculate the optimal external force that compensates for the ZMP tracking error. This optimization considers multiple contacts positions within the environment by formulating the problem as a Mixed Integer Quadratic Program (MIQP) that can be solved at a speed between 100-300 Hz. Once contact is created, the MIQP reduces to a single Quadratic Program (QP) that can be solved in real-time ({\textless}; 1kHz). Simulations show that the presented walking control scheme can withstand disturbances 2-3× larger with the additional force provided by a hand contact.

am mg

am mg Mason, S., Rotella, N., Schaal, S., Righetti, L. An MPC Walking Framework With External Contact Forces In 2018 IEEE International Conference on Robotics and Automation (ICRA), pages: 1785-1790, IEEE, Brisbane, Australia, May 2018 (inproceedings)

Interpreting FORC diagrams beyond the Preisach model: an experimental permalloy micro array investigation

Gross, F., Ilse, S., Schütz, G., Gräfe, J., Goering, E.

In 2018 IEEE International Magnetics Conference (INTERMAG 2018), IEEE, Singapore, 2018 (inproceedings)

mms

mms Gross, F., Ilse, S., Schütz, G., Gräfe, J., Goering, E. Interpreting FORC diagrams beyond the Preisach model: an experimental permalloy micro array investigation In 2018 IEEE International Magnetics Conference (INTERMAG 2018), IEEE, Singapore, 2018 (inproceedings)

2006

Ab-initio calculations: I. Basic principles of the density functional electron theory and combination with phenomenological theories

Fähnle, M.

In Structural defects in ordered alloys and intermetallics. Characterization and modelling, pages: IX-1-IX-10, COST and CNRS, Bonascre [Ariege, France], 2006 (inproceedings)

mms

2006

mms Fähnle, M. Ab-initio calculations: I. Basic principles of the density functional electron theory and combination with phenomenological theories In Structural defects in ordered alloys and intermetallics. Characterization and modelling, pages: IX-1-IX-10, COST and CNRS, Bonascre [Ariege, France], 2006 (inproceedings)

Hard magnetic FePt thin films and nanostructures in L1(0) phases

Goll, D., Breitling, A., Goo, N. H., Sigle, W., Hirscher, M., Schütz, G.

In 13, pages: 97-101, Beijing, PR China, 2006 (inproceedings)

mms

mms Goll, D., Breitling, A., Goo, N. H., Sigle, W., Hirscher, M., Schütz, G. Hard magnetic FePt thin films and nanostructures in L1(0) phases In 13, pages: 97-101, Beijing, PR China, 2006 (inproceedings)

Ab-initio calculations: II. Application to atomic defects, phase diagrams, dislocations

Fähnle, M.

In Structural defects in ordered alloys and intermetallics. Characterization and modelling, pages: XIV-1-XIV-11, COST and CNRS, Bonascre [Ariege, France], 2006 (inproceedings)

mms

mms Fähnle, M. Ab-initio calculations: II. Application to atomic defects, phase diagrams, dislocations In Structural defects in ordered alloys and intermetallics. Characterization and modelling, pages: XIV-1-XIV-11, COST and CNRS, Bonascre [Ariege, France], 2006 (inproceedings)

Movement generation using dynamical systems : a humanoid robot performing a drumming task

Degallier, S., Santos, C. P., Righetti, L., Ijspeert, A.

In 2006 6th IEEE-RAS International Conference on Humanoid Robots, pages: 512-517, IEEE, Genova, Italy, 2006 (inproceedings)

Abstract

The online generation of trajectories in humanoid robots remains a difficult problem. In this contribution, we present a system that allows the superposition, and the switch between, discrete and rhythmic movements. Our approach uses nonlinear dynamical systems for generating trajectories online and in real time. Our goal is to make use of attractor properties of dynamical systems in order to provide robustness against small perturbations and to enable online modulation of the trajectories. The system is demonstrated on a humanoid robot performing a drumming task.

mg Degallier, S., Santos, C. P., Righetti, L., Ijspeert, A. Movement generation using dynamical systems : a humanoid robot performing a drumming task In 2006 6th IEEE-RAS International Conference on Humanoid Robots, pages: 512-517, IEEE, Genova, Italy, 2006 (inproceedings)

Residual stress analysis in reed pipe brass tongues of historic organs

Manescu, A., Giuliani, A., Fiori, F., Baretzky, B.

In Residual Stresses VII. 7th Europen Conference on Residual Stresses (ECRS7), pages: 969-974, Trans Tech, Berlin [Germany], 2006 (inproceedings)

mms

mms Manescu, A., Giuliani, A., Fiori, F., Baretzky, B. Residual stress analysis in reed pipe brass tongues of historic organs In Residual Stresses VII. 7th Europen Conference on Residual Stresses (ECRS7), pages: 969-974, Trans Tech, Berlin [Germany], 2006 (inproceedings)

Design methodologies for central pattern generators: an application to crawling humanoids

Righetti, L., Ijspeert, A.

In Proceedings of Robotics: Science and Systems, Philadelphia, USA, August 2006 (inproceedings)

mg Righetti, L., Ijspeert, A. Design methodologies for central pattern generators: an application to crawling humanoids In Proceedings of Robotics: Science and Systems, Philadelphia, USA, August 2006 (inproceedings)

Programmable central pattern generators: an application to biped locomotion control

Righetti, L., Ijspeert, A.

In Proceedings of the IEEE International Conference on Robotics and Automation, 2006. ICRA 2006., pages: 1585-1590, IEEE, 2006 (inproceedings)

mg Righetti, L., Ijspeert, A. Programmable central pattern generators: an application to biped locomotion control In Proceedings of the IEEE International Conference on Robotics and Automation, 2006. ICRA 2006., pages: 1585-1590, IEEE, 2006 (inproceedings)

High-pressure influence on the kinetics of grain boundary segregation in the Cu-Bi system

Chang, L.-S., Straumal, B., Rabkin, E., Lojkowski, W., Gust, W.

In 258-260, pages: 390-396, Aveiro (Portugal), 2006 (inproceedings)

mms

mms Chang, L.-S., Straumal, B., Rabkin, E., Lojkowski, W., Gust, W. High-pressure influence on the kinetics of grain boundary segregation in the Cu-Bi system In 258-260, pages: 390-396, Aveiro (Portugal), 2006 (inproceedings)